Cutting list

Holder 24pieces

Length 190 width 15 height 45

4 pieces of 580mm long timber divide by 3 = 190

580 *2=1.116                                                

1.2M long*150width 50height timber required

1.2M long timber cut in to the size of 580*45*45.  6pcs of 580*45*45 .4 pics for holder and 2pcs for braces.

s

Braces 4pieces  (offcut from holder)

580mm long timber divide in to 4 squares,

 length580 width 20 height20

   

  

Block (16pieces) need to cut in half (32 pcs)
Length90 width 45 height45
16*90/3=0.480
0.5M  long 150 widith timber required

 

Customwood(MDF)
width 15 height 150

2pcs of 575mm long, 6pcs of 560mm and 4 pcs of 272.5mm.(CI=575, 575/2-15=272.5)

material used
2M long 150width 50height pine
1220 long 300 width MDF

MDF (Sawn Frames)

MDF

2^nd thing what we’ve done was to make temporary flame which goes top of the male strong back.

We took 3 sheets of MDF frame which were size of 2440*1220 .

We had our offset drawing from tutor but there was some missing information so we need to check original Autocad document in student drive.

`

Firstly, we lined outlines 20mm on the sides 10mm top and bottom then begin to draw other station frames in to MDF.

 We used jig saw to nearest size.we planed and sanded  the outlines .the outline must have to be flat but we didnt realise at the beggining so we planed it twice....

While william and i  still planning yin started to develop transom lines and Lim,Stephen begin to draw stems of our boat.

Small craft build(male strong back)

At the end of last term we were spilted in to 3 groups cause we are buliding 3 different boats in this term

2.5M dinghy , 4M dory, and 2.4M Pippi.My group is making 3.4M dory.

Today, we just started Small Craft build and starts to make 4M dory

and the time we have is 6weeks and 2days.

We talked about timeline and brainstorming information about dory.

The 1st thing what we've done was to find the table  for 4M dory but, all the table wasn't long enough so we had to extend the table by our selves.After measuring height, width , and extension length we could make our cutting list.

-600*2          -810 *4 legs     -4screw blocks

-2braces        -1000*2 Extension

 we used pine whole length of 2800, width of 150 and height of 50.

After dressing and cutting the pine in to a piece,the rest of our group have finished drilling male strong back to the floor by using screw blocks.Also they made table exactly parellel  by using label.